The ATFP200T is an un-powered pellet mill with a 200 mm diameter die, the holes in the die can be pretty much whatever size you would like. It is designed to be powered by a 550 rpm PTO from a tractor. It is not designed to be run by a motor or engine. It is rated at 220 to 440 lbs per hour of production depending on the type of material you want to pelletize. Wood is much more difficult to pelletize than grasses or grains and you should probably not use this mill to make wood pellets, it doesn’t have enough torque. To make wood pellets please check out my wood pellet mill page.

This mill will require a tractor with at least 12 to 15 HP available at the PTO. This mill comes complete with the Jack Shaft but you will have to construct your own 3 point hitch and likely as not the PTO U joint will need a different spline coupling due to the difference between US and Asian tractors. This mill weighs 330 Lbs and its dimensions are 28 X 21 X 42 inches. Spare Die is $105 Spare Roller assy is also $105. Figure on changing the die and roller every 1600 hours of normal operation, but rocks, bolts etc. can damage them beyond use, so I recommend you keep a set of spares.

$1029.00 Plus shipping.

Leave a Reply

Your email address will not be published.

1 × 3 =